Post - maintenance of three - dimensional motion mixer

For the mixer to give you some other mixer classification. There are the following: small mixer, V-type mixer, three-dimensional mixer and slot mixer. What are the characteristics of their brief introduction?
Three-dimensional mixer: three-dimensional motion mixer charging the cylinder in the initiative driven by the axis, for the cycle of translation, rotation and roll and other complex movement, to promote the material along the simplified three-way movement, in order to achieve a variety of materials Flow, diffusion, accumulation, doping. To achieve the purpose of uniform mixing. Product use The machine mixed with the multi-directional movement of the material, the material without centrifugal force, no heavy segregation and stratification, accumulation phenomenon, the components may have a disproportionate weight ratio, the mixing rate of 100% or more, is the various mixers Ideal product.
Small Mixer:
The mixing of the small mixer is a single shaft of the shaft, and the angle of the paddle on the single paddle is very reasonable and clever. When the single blade rotates, the material rolls up and down, and the blade passes through the material and produces a certain angle to the left and right sides of the mixing tank Force, so that any corner of the mixing tank material can not be static, so that the material mix evenly. The machine is used in the face seal, adjust the sealing nut, compensation for axial pressure sealing method. This method has proven to be effective by long practice.
The first step is to check whether the three-dimensional motion mixer grease is added in the pipeline for gas injection.
The second step is to check whether the nozzle is blocked.
The third step is to check the filter tank in the screen is damaged.
The fourth step is to adjust the angle of the nozzle, try not to let the oil spray to both ends of the mixer wall and paddle.
Fifth, of course, appropriate control of the heating temperature of grease to prevent excessive oil spray to the material produced in the oil group.
The sixth step in the three-dimensional motion mixer process to increase the mixed product after the test sieve, the mixed oil group to get rid of.