How to use feed mill properly

How to use feed mill properly
1. Crusher long-term operation, should be fixed on the basis of cement. If you frequently change the workplace, grinder and motor to be installed in the corner made of iron on the base, if the crushed
The diesel engine power, should make the two power match, that is, the diesel power is slightly larger than the pulverizer power, and make the two belt groove groove, pulley outer end face in the same plane.
2. After the installation of the crusher to check the fastening of the Department of fasteners, if loose to be tightened.

3. To check the belt tightness is appropriate, the motor shaft and shredder shaft is parallel.
4. Before starting the pulverizer, first turn the rotor by hand, check whether the claw, hammer and rotor operation is flexible and reliable, whether the shell collision phenomenon, whether the rotor rotation and machine
The direction of the arrow on the same direction, the motor and powder machine lubrication is good.
5. Do not casually replace the pulley, to prevent the speed is too high to make the crushing chamber explosion, or the speed is too low affect the work efficiency.
6. After the start of the crushing station idle 2 to 3 minutes, no abnormal phenomenon after feeding work.
7. Work at any time to pay attention to the operation of the shredder, feeding to be uniform, to prevent blocking the car, do not run for a long time overload. If found to have vibration, noise, bearing
And the body temperature is too high, outward spray and other phenomena, should immediately stop the inspection, troubleshooting can continue to work.
8. Crushed material should be carefully checked to avoid copper, iron, stones and other hard objects into the crushing chamber caused by the accident.
9. Do not wear gloves, the operator should be placed on the side of the pulverizer, to prevent the backlash hit the face.